12V 6A Diesel Generator Engine Battery Charger Module 24V 3A Power Intelligent Float Charger Adapter Accessories(24V 5A)

Battery ChargersSUMMARYBAC06A series switching battery charger using the latest swtich power components is desigened for charging lead-acid starting battery which is suitable for lead-acid battery float charge.The maximum charging current for 12V charger is 6A and the maximum charge current for 24V charger is 5A.> P ERFORMANC E AND CHARACTERISTICS .1. Designed in switching power structure , wide range of AC voltage input, smallvolume,light weight and high effciency;2. Two-stage charging method (constant current firstly and then constant voltage ), fully considering charging property of the lead-acid battery , can avoid overcharging and extend the battery life to the fullest;3. With short circuit and reverse connection protection; .4. Charging voltage and current can be adjusted via potentiometer on the spot.5. LED display: AC power indication and charging indication;6. Horizontal type for installation of BAV06A, easy to install;Considering charging property of the lead-acid battery ,BAC06A battery charger uses 2-stage charging method and charge mode is"constant-current". When battery voltage is under the threshold, it is charging in constant-current mode ; when the battery voltage is higher than the threshold , the charging 1 current is decreasing as the battery voltage is rising until it reaches the set voltage,and then charge mode is turned into"floating charge". Charge current is gradually reducing and battery voltage is rising up to the set value.When charging current is lower than 0.3A(24V 5Ato 0.5A),the battery is basically fully changed (charging indicator eliminates) . Afterwards , charging current will offset self-discharge of the battery . Thus the charger can maintain . a full charged condition and extend the battery life.S ETTINGVoltage Adjustment When adjusting the voltage ,disconnect the battery from the charger, and then measure the output voltage of the charger while adjusting voltage potentiometer (VOLT) to a proper value.Current AdjustmentConnect battery output firstly.When battery voltage is under 25.0V (12.5V), adjust the current potentiometer (AMP) and set proper charge current . Output current can also be estimated according to the current potentiometer, which is recommended.1. Terminals L and N connect AC 220V, using multi-strand BVR 1mm2 copper wires.2. erminals B+ and B- connect battery positive and negative, using multi-strand BVR 1 .5 mm2 copper wires.3. POWER: Power indicator. When charger works, it'll iluminate.4. CHARGING : Battery charging indicator . When charging current is over 0.3A (0.5A), it will iluminate.5. VOLT: Voltage adjustment potentiometer.6. AMP: Current adjustment potentiometer.7. Output 10A fuse . Reverse connection will cause fuse blown . After correcting the connection and changing another fuse, it can continue working.8.Procedures of changing fuse:a. Press hard on the slotted screwdriver ,screw counter-clockwise and then take out the fuse . Improper operation or over tightening may damage the block.b. Put a fuse into the block, press the slotted screwdriver and screw clockwise.Note:1. Because there is diode and current-limiting circuit inner the charger, it can be used together with charging generator, and there is no need to disconnect the charger when cranking.2. During genset is running ,high current will cause voltage drop in charging line ,so recommend separately connecting to battery terminal to avoid disturbance on sampling precision.==========Hign-concerned Chemical : None

• Battery Chargers
• 12V 6A Diesel Generator Engine Battery Charger Module 24V 3A Power Intelligent Float Charger Adapter Accessories